Jump to content

How to stop a running start-up scan via cloud console


beethoven
 Share

Recommended Posts

A pc linked to our cloud network has not been turned on for a while as it was not used. It now requires some modifications but upon startup a scan initiated. This apart from the usual updates makes the pc quite unresponsive. 

What is the best way to stop a running scan?   I tried to run a command to pause protection (ecmd /setfeature onaccess pause) but this probably only becomes relevant after the scan is finished. I can't seem to find a command to abort a scan remotely?

Link to comment
Share on other sites

In case someone else is interested, it seems 
"Unfortunately, there is no way to cancel or stop a running task. It will timeout at some point if the execution was interrupted in a way that a response was not possible (for example, a system restart)."  

A bit disappointing as in this case the status as shown in the task will often show something as running when in fact the scan was aborted midway and is no longer active.

 

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...