Marna Marie' Strauss 0 Posted May 15, 2018 Share Posted May 15, 2018 Hi there, How do I know that my LDAP is setup correct? I can see 500 rogue devices, which I'm now busy importing. Do I install the ERA client on my workstations then import them into my ERA server? One last question, how do I see the settings for my clients to update from ERA? normally it was https://IP:2222 . did this change? Please advise, thank you. Link to comment Share on other sites More sharing options...
j-gray 31 Posted May 15, 2018 Share Posted May 15, 2018 If your sync is configured for computers and groups, you should see your directory structure replicated within the ERA console. The Remote Admin port is still 2222, unless you manually changed it within the ERA console (under Admin > Server Settings > Connection) Link to comment Share on other sites More sharing options...
Marna Marie' Strauss 0 Posted May 16, 2018 Author Share Posted May 16, 2018 Thank you @j-gray I can see the directory structure, just trying to figure out how to get the machines "managed". I installed the Remote Agent yesterday, will check again today. Thanks for your answer. Link to comment Share on other sites More sharing options...
Administrators Marcos 4,704 Posted May 16, 2018 Administrators Share Posted May 16, 2018 After deploying Agent to endpoints (e.g. via GPO as per the instructions at https://support.eset.com/kb3675/), Agent should start reporting to ERAS. Link to comment Share on other sites More sharing options...
Recommended Posts