Jump to content

How to create an trigger on Dynamic group of install fails to rerun again


tcmclijs
 Share

Recommended Posts

Hi,

 

On Dynamic groups the install tasks only run once. How can I set a trigger that if a task fails it will rerun until the task is successfully completed?

Now it is set when a client is added to the Dynamic group the install task runs. But when it fails it never runs again and I have to do a manual install task, which is not preferable with 300 endpoints.

Link to comment
Share on other sites

Great question.. I have 800 endpoints...

I did figure out how to change the task Expire to a later date....

Edited by dlaporte
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...