Jump to content

Since ESS v9 , Lexware Faktura & Auftrag takes 10 seconds to start and close


Recommended Posts

hi,

 

I am using "Lexware Faktura & Auftrag" and with Eset ESS v8 all was ok,

but since ESS v9 Lexware needs 10 seconds to start and to close.

 

So I uninstalled Eset and removed the eset folder in C:\ProgramData

and re-installed Eset to get fresh firewall rules ... but still the same problem in the automatic and interactive mode.

just when I block all traffic, lexware will start / close in 1 second.

 

so I uninstalled eset v9 and reinstalled v8, here it works as it should, no problems,

so uninstalled v8 and re-installed v9... and again the same problem.

 

When I use the interactive firewall mode, there is no popup if I want to grant access lexware to the internet 

or something.

 

What can I do ?

Link to comment
Share on other sites

  • Administrators

 

just when I block all traffic, lexware will start / close in 1 second.

 

I assume the problem went away after allowing all traffic, ie. after disabling the firewall. Could you confirm?

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...