Jump to content

Archived

This topic is now archived and is closed to further replies.

davidenco

Why has this option been removed??

Recommended Posts

In ESMX 6.5, I used the "Header with the originating IP" found under Server > Mail Transport Protection > Advanced Settings, and found it especially useful for cases where our email was ever temporarily held by our secondary MX as ESMX was treating the originating IP address as the secondary MX.

In ESMX 7.0, this option has been removed, but there is no mention of the removal in the change logs or release notes. As far as the documentation is concerned, there is no option and never was.

In ESMC 7.0, the policy for ESMX is labelled "V6+" so the option should still be visible for V6 clients, but it's not, even if creating a brand new policy.

Where has the option gone?

Share this post


Link to post
Share on other sites

It seems that the option was removed due to a new algorithm for selecting sender's address implemented in EMSX v7. The option can still be configured via a configuration xml file if really needed or to keep it enabled after upgrade.

Share this post


Link to post
Share on other sites

Hi,

Another reason for removing the option from screens was that it was misused most of the time (lowering the detection rate of antispam engine). However, it's still supported by the backend and can be configured using XML.

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...