robg 0 Posted January 11 Share Posted January 11 ESET Endpoint Antivirus ESET, spol. s r.o. 8.0.2028.0 214 yes 8.0.2028.0 Up-to-date version en_US ESET Management Agent ESET, spol. s r.o. 8.0.1238.0 272 yes 8.0.1238.0 Up-to-date version en_US Idle scanning is enabled in the profile but recently it noticed it seems to take a minute to stop when I log back in, and runs at 100% disk usage until it stops making the computer crawl until it finishes. Is there any fine control over Idle Scanning I can enable or is this expected behaviour. Never noticed it in the past. Time;Component;Event;User 11/01/2021 12:01:52;Computer scan;Idle scanner: scan started.;SYSTEM 11/01/2021 12:10:26;Update;Updater: UpdPerformPicoUpdate for pico_id 1 with interval 10 returns = 0x0000;SYSTEM 11/01/2021 12:20:26;Update;Updater: UpdPerformPicoUpdate for pico_id 1 with interval 10 returns = 0x0000;SYSTEM 11/01/2021 12:28:54;Computer scan;Idle scanner: scan finished.;SYSTEM 11/01/2021 12:30:26;Update;Updater: UpdPerformPicoUpdate for pico_id 1 with interval 10 returns = 0x0000;SYSTEM I logged back in at 11/01/2021 12:27:17 Link to post Share on other sites
Administrators Marcos 3,634 Posted January 11 Administrators Share Posted January 11 You can try disabling scanning of archives and sfx archives in the idle-state scanner setup since the delay is most likely caused by scanning certain archives on the disk. Link to post Share on other sites
robg 0 Posted January 11 Author Share Posted January 11 Will give that a go Link to post Share on other sites
itman 955 Posted January 11 Share Posted January 11 In ThreatSense parameters for Idle-Scan option, verify that the scan is set to low priority. See if this helps with the logon issues: Link to post Share on other sites
Recommended Posts