Add Protocol Filtering IP Exclusion from ERAC

[rockshox 5]

Is it possible to add an IP Address exclusion to Protocol Filtering from the ESET Remote Administrator Console? In the client it is located at Web and email > Protocol Filtering > Excluded IP addresses. It seems like I've seen it in the Policy Manager before, however today when I need to use it, I can't seem to locate the correct setting.

 

 ERAS 5.1.38

[Arakasi 549]

I looked everywhere for this

One part did state, filtering based off rules, and the rule being used was client side rules created.

Still searching

[Bart 4]

Hi guys

 

In ERA new task go to Firewall->settings->rules configuration and in tab Zones there is option add  exceptions for protocol filtering (if it's not visible click: Add default )

 

Sorry if i made some mistranslation but i'm not sure how excacly it's in ENG ( Using polish )

Edited April 3, 2014 by Bart

[rockshox 5]

Bart - Thank you for the information, you were in fact correct. In the English version it is under Personal Firewall > Settings > Rule Setup.

 

Thanks Arakasi for looking, I never would have found it either since we are running ESET Endpoint Antivirus which supposedly does not include a firewall, but the setting is under "Personal Firewall"....somehow that makes sense? 

[Arakasi 549]

Absolutely since its filtering network protocols.

[Marcos 4,713]

Protocol filtering is part of the firewall which is partially implemented in Endpoint Antivirus, too.