Jump to content

Add Another Netwok Range To ESMC


Recommended Posts

Dear All

Here is our situation ESMC server ip address is in the range 10.10.10.xxxx, All clients in this range can be managed from ESMC. We have nother internal network with another range 192.168.0.xxxx , the two networks are connected but in ESMC we can't see the desktops with the 192.168.0.xx range , how can we manage that other network from ESMC.

 

Thank you 

Link to post
Share on other sites
  • ESET Staff

Could you be more specific of where you are not seeing devices? Not sure I understand, but in case you mean "rogue" devices as detected by "ESET Rogue Detection Sensor", problem might be in fact that only devices in the same subnetworks as this component is installed are detected. In order to detect rogue devices in different network, you will have to deploy one AGENT and Rogue Detection Sensor inside of this network.

Link to post
Share on other sites

Thank you for your reply , could you please provide more information where will the one AGENT and rogue detection sensor be installed , To calrify more yes we want to detect rogue devices in a different metwork 

 

Thanks

Link to post
Share on other sites
  • ESET Staff
4 hours ago, Riadg said:

Thank you for your reply , could you please provide more information where will the one AGENT and rogue detection sensor be installed , To calrify more yes we want to detect rogue devices in a different metwork 

 

Thanks

As Rogue Detection Sensor uses passive detection on network, I would recommend to install it ( also with ESET Management Agent ) on gateway, but also any client machine in required network should slowly detect all devices. Installed AGENT has to connect to your ESMC to report detected devices.

Link to post
Share on other sites
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...