pps

6.6.2078.5 unable pause the firewall

Recommended Posts

Hello,

In the last version of endpoint security 6.6.2078.5  when I click the "pause firewall  (allow all traffic) " there is no prompt for admin credentials and I cannot pause the firewall.

This issue reproduced in all workstations that I tried (more than 6).

"Block all network traffic" button has the same behavior also.

Thanks,

Peter

image.png.4eecc5eb15c1f37cd80c9cd2bc5bced8.png

 

 

Share this post


Link to post
Share on other sites

Couldn't it be that you have enabled the firewall via a policy? Ie. is there a padlock icon next to "Enable firewall" in the advanced setup?

Share this post


Link to post
Share on other sites

Hello Marcos,

 

Yes it is but before 6.6.2078.5 I was able to pause it and the firewall policy hasn't change till 6.6.2052.

And I cannot left this setting unlock because then the users will be able to close the firewall on their own.

 

image.thumb.png.f2b7f084618be1c736ead8e57a96c6c9.png

image.png.655590d12e981662a741c5cb1a1f07ff.png

 

 

 

Share this post


Link to post
Share on other sites

That's how it currently works but it may change in the future. If the firewall is enforced by a policy, you can enter override mode in order to be able to temporarily pause the firewall.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Recently Browsing   0 members

    No registered users viewing this page.